I had my Untangle installation well over a year and it has been fine until now. For some reason it cannot connect to internet. My Untangle server sits between my Cable modem and my wireless router. I tested a direct connection to my modem using my laptop and it works just fine.
After hours of troubleshooting, including swapping out NIC's, I decided to just perform a new installation from scratch. I seem to be stuck at the Internet Connection step during the Installation Wizard. I have connection type as Dynamic (DHCP) but DHCP status is all blank. It has not detected anything. When I click the Test Connectivity button the test fails. This was the same configuration since the beginning.
Can anyone point in the right direction as to where else I need to look for this? Is there perhaps something on my Cable modem that is preventing this? The modem is not new and I have not modified any configurations.
After hours of troubleshooting, including swapping out NIC's, I decided to just perform a new installation from scratch. I seem to be stuck at the Internet Connection step during the Installation Wizard. I have connection type as Dynamic (DHCP) but DHCP status is all blank. It has not detected anything. When I click the Test Connectivity button the test fails. This was the same configuration since the beginning.
Can anyone point in the right direction as to where else I need to look for this? Is there perhaps something on my Cable modem that is preventing this? The modem is not new and I have not modified any configurations.